• Magnetically attached rail & riser for the Shelf Management System
• Overall Length: 914MM
• Colour: Natural
• 25MM Magnetic Strip
• 39MM Front Riser
• Used on steel shelves only
• Incorporates a "T" bar on which dividers are affixed

A rail / riser has 2 functions - to give a fixture onto which our dividers are snapped, and also to give a small barrier to stop stock falling off a shelf. The magnetic base of the rail / riser allows you to quickly lay the strip down on the front of a shelf and the advantage (being magnetic) is that this can be removed or adjusted quickly at any time.

When setting up a shelf management system, one needs to have 2 rails - one on the front of a shelf and one on the rear. We do supply single magnetic rails (without risers) that can be used as the rear rail however, as a tip, the system works fine with an adhesive rail (and it's cheaper!) and what's more, if you use a rear adhesive rail, there's no need to peel off the tape backing paper and stick it to a shelf...it can free-float and works very well.When setting up a system using a magnetic rail / riser:
1. Lay down the front rail (or rail / riser)
2. Lay down the rear rail (magnetic or adhesive)
3. Snap on suitable dividers to both the front and rear rail.
4. Adjust the position of the dividers by sliding them along the rails.

The magnetic rail / riser is a great way to keep products organised and the 39mm high riser will also act as a barrier to stop items from falling off the front of a shelf.




Shipping Weight 0.2500kg
Shipping Width 0.040m
Shipping Height 0.915m
Shipping Length 0.035m
Shipping Cubic 0.001281000m3

More From This Category